Threading the machine, Running the machine – SINGER 2210 Athena User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading the Machine
The top thread is now ready to be threaded into the machine. Proceed as foltows:
• Raise needle and presser foot to their highest positions.
*
Lead ttiread from spool on spool pin and snap into top thread guide (1) by
grasping thread with two hands and snapping it down into top of guide.
♦ Foilovving arrows in illustration, guide thread across top of machine, down the
right hand channel through the tension discs, under the bottom of the chan*
nel separator (2), and up the left hand channel.
♦ At the top of the left thread channel (3), pull the thread to the left into the self*
threadir^g take*up lever and then down to the needle going through guides (4)
and (5) on needle clamp.
NOTF: Do not thread lower guide (5) if you are using heavy thread.
• Lower the presser foot and thread the needle from front to back drawing about
4 inches (10 cm) through the eye of the needle.
12