Changing needles, Removing needleplaie, Replacing needleplate – SINGER 2210 Athena User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Changing Needles
« Raise needle to highest position by turn
ing handwheel towards the operator.
♦
Loosen needle clamp screw (1) and
remove needle.
♦ With hat side of needle to the back, in
sert new needle into damp (2) as far as
it v/lil go.
♦ Tighten needle damp screv/ (1) securely.
Check the Fabric, Thread and Needle Chad
in this book for correct needle and fabric
combinations.
Removing Needleplaie
For either cleaning or use of the straight
stitch plate, available from an approved
dealer, do the following:
♦ Raise needle and pressor foot to their
highest position.
♦ Open slide plate and place thumb under
right side of needle plate (3).
♦ Lift up and pull plate to the right to
remove it from the machine.
Replacing Needleplate
• Holding needle plate as shown, slide it to
the left under the head of damping pin (4).
•
• Press down on right side at (3) until it fits
securely in place.