Winding the bobbin – SINGER 2210 Athena User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Winding of the bobbin is done before threading machine:
♦ Place spool of thread on spool pin (1).
* Choose size of spool holder (2) to fit spool. Slide it onto pin snugly against
spool to keep spool from turning.
♦ Lead thread into top thread guide (3) by snapping it down into lop of guide
with two hands.
♦ Proceed to thread tension (4) wrapping thread ortce around in a clockwise direc-
tion.
* Guide end of thread through small hole in top of bobbin (5) and place bobbin
onto bobbin winder (6).
* Push bobbin winder to the right to engage the drive system and to disengage
sewing mechanism for winding.
♦ Hold thread end coming through hole in bobbin and start motor. V^ind slowly.
Stop after a fev/ turns to trim end, then continue v/Inding to desired fullness.
NOTE: Bobbin will stop turnifig by itself vdien full, but sewing mechanism must
be reset by the operator.
• Release speed controller and push winder to the left to reengage sewing
mechanism.
Winding the Bobbin
10