SINGER 2210 Athena - Manual (Page 11)

Attaching Feed Cover
I'or darning and free molion embroidery, the
feed cover prevents the feed from moving
the
material. Attach ft as follows:
♦ Raise needle and presser foot, and open
slide plate.
♦ Slide feed cover on top of needle plate,
pressing tabs (1) and (2) into holes in
needle plate. Then, close slide plate.
t
® To remove, open slide plate. Lift frord
edge of cover (3) and pull it away.
If operator prefers to do these operations by
removing presser foot and shank from
machine, be sure presser bar is lowered to
maintain proper thread tension.
Attaching Darning and Embroidery Foot
A Special presser foot is included as an ac-
cessory for use In darning, embroidery, and
machine basting. Attcich it to the machine
as follov/s:
♦ Raise presser bar (1) and remove existing
presser foot with attached shank follov/-
ing directions under “Changing Screw on
Presser Feet'L
♦ Wi th need I e I n t h e u p pos i t i on, g u i de dar*
ning and ernbroidety foot (2) onto presser
bar from the rear of the machine, hook-
ing it around the bar (1) and under the
screv^ (3).
♦ Make sure tab (4) of foot is fitted on top
of the needle clamp screw (5). This pro­
vides the automatic lifting of the foot for
manual positioning of the fabric when
needle is in the “up” position and out of
fabric.
♦ Tigtiten
screw
(3) snugly using a coin.