SINGER 5805 - Manual (Page 22)

Inserting a bobbin
• Raise presser foot.
• Turn hand wheel toward you until needle Is
In Its highest position.
• Open slide plate and remove empty bobbin.
1. Pull 4” (10 em) of thread from replacement
bobbin and Insert bobbin into case, as
shown.
J
2. Holding bobbin In place, guide thread Into
1
notch (1) and then down the slot to the left
I
and guide around Into notch (2).
3. Draw several Inches of thread diagonally
across the bobbin toward the back of the
machine.
{ 4. While holding thread on outside, close the
slide plate, allowing thread to extend
through the slot between the slide plate
and needle plata
20