Attaching the feed cover (f), Changing snap-on presser feet (b), (d), J). (l) – SINGER 5805 User Manual
Page 18: Attaching the feed cover
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attaching the feed
cover (F)
The feed cover is used to keep the feed from
moving the fabric when attaching a button,
darning or sewing tree-motion embroidery.
To attach It, follow the directions below:
• Raise needle and presser foot.
• Open slide plate.
• Slide feed cover on top of needle plate,
pressing tabs (1) and (2) into holes.
• Close slide plate.
• To remove, open slide plate and lift front
edge of cover; pull It away.
Changing snap-on
presser feet (B), (D),
(J). (L)
• Raise needle to Its highest position by turning
hand wheel toward you.
• Raise presser foot using presser foot lifter at
back of machine.
• Push toe of presser foot (1) up, until it snaps
off the shank (2).
• Remove foot from machine.
• Place new foot under centre of shank.
• Lower presser foot lifter, fitting shank over
presser foot pin (3).
• Don’t turn screw. Instead, push presser foot
screw (4) down, firmly until foot snaps
into place.
! 16