Replacing the device fuse – VACUUBRAND PC 3012 VARIO plastic housing User Manual
Page 121
page 121 of 129
fuse holder
➨
Unscrew the fuse holder using a slotted screw driver.
➨
Replace the defective fuse by a fuse of the same type (see “Technical
data”, pg. 26). Reassemble holder with fuse to the pump.
Pumps NT VARIO
Pumps VARIO-B /
PC 301x VARIO
PC 300x VARIO
fuse holder
➨
Keep the snap-fit squeezed and pull the fuse holder out.
➨
The fuse holder contains two fuses of the same type. Replace the de-
fective fuse by a fuse of the same type (see “Technical data”, pg. 26).
➨
Insert the fuse holder into the housing of the pumping unit until it snaps.
Replacing the device fuse
➨
Switch off the pump.
➨
Disconnect the electrical power cord before un-
screwing the fuse holder.
Identify and eliminate the cause of failure before switch-
ing on the pump again.