Tuffy Security 167 - Manual (Page 2)

Page 2 of 4 – 10/13/2010 – Rev6/8/2011
FIGURE 1
3. The drawer is shipped without the Mounting Brackets #8 installed due to the wide variety of mounting point locations
in different vehicles. Place the drawer enclosure in the vehicle in the desired mounting location and mark where the
#8 mounting brackets should be located. The #8 mounting brackets should be directly above the anchors used for the
seat mounts if available. Make sure the rear door of the vehicle shuts with the drawer installed and the seats function
properly. (See Figure 2 for the Chevy Tahoe standard mounting location)
FIGURE 2
(Chevy Tahoe standard mounting location shown, mounting bracket location varies by vehicle)
4. Remove the Enclosure from the vehicle and fasten the #8 Mounting Brackets to the enclosure with the #5.2.4 bolts,
#5.2.2 nuts and #5.2.3 washers. These bolts are difficult to reach; Use a ½” shallow socket with a long extension and
a ratchet (Universal joint also helps) and a ½” wrench on the other end. Unbolting the slide using a 7/16” wrench will
make things easier as well. (See Figure 3)
If the vehicle is not equipped with seat anchor points or the drawer requires additional mounting points you can drill 3/8”
holes in the floor aligned with holes in the #8 mounting brackets and fasten the drawer to the floor using the hardware
provided with the #14 clamps on the underside of the vehicle floor. Warning! Be sure there is nothing on the
underside of the vehicle floor which will be damaged when drilling. Most vehicles have a gas tank and gas lines
in that area.