Tuffy Security 025 - Manual (Page 2)

Page 2 of 2 - 2/21/2013 – Rev122006
6. Do not place the trunk in the vehicle until step 8. Install (4) 5/16 x 1 ¼” bolts with (4) 5/16”
washers up from underneath in the holes in the vehicle. Fasten the bolts to the floor with (4) 5/16”
washers and (4) 5/16” nylock nuts. (SEE FIGURE 2)
7. Place the trunk back in the vehicle over the bolts fastened to the floor. Secure the trunk down to the
bolts using (4) 5/16” washers, and (4) 5/16” nylock nuts. (SEE FIGURE 2)
ATTENTION:
FREQUENT LUBRICATION IS NECESSARY ON THE LOCKING SYSTEM
The pushbutton lock contains
an “O” ring seal to protect the interior from dust and water. If this
mechanism is not lubricated regularly it will become difficult to operate and it may not return to its
home position preventing the key from operating the lock. If this happens simply pull up on the
pushbutton to manually bring it back to its home position. Lubricate the pushbutton with a light
lubricant such as silicone spray. The pushbutton may have to be periodically disassembled and
cleaned.
Call (970)564-1762 for Technical Support