Tuffy Security 025 - Manual

Page 1 of 2 - 2/21/2013 – Rev122006
INSTALLATION INSTRUCTIONS
Storage Trunk Part #025
Please read and fill out the enclosed warranty registration card to activate your warranty.
PARTS CHECKLIST
(4) 5/16 x 11/4” BOLTS
(4) 5/16 NYLOCK NUTS
(12
) 5/16” WASHERS RUBBER SEAL
TOOLS NEEDED

Electric drill
 3/8” Drill bit

Marker or pencil

Knife
 ½” Socket and ratchet
 ½” Wrench

Silicone sealant (Recommended)
PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.
1. Install rubber seal on lid and check lock operation. (SEE FIGURE 1)
2. Place the trunk in the vehicle and center it making sure the tailgate will latch shut, and the seat will
fold and tumble(if applicable).
3. Using a marker or pencil, mark (4) spots through the 3/8” mounting holes in the trunk.
WARNING!
Make sure that there is nothing under the vehicle that will be damaged by the drill bit when drilling.
IN MOST VEHICLES THERE IS A GAS TANK UNDERNEATH THE REAR OF THE VEHICLE.
THE GAS TANK MAY HAVE TO BE LOWERED TO INSTALL THE MOUNTING BOLTS.
PLEASE CONSULT VEHICLE OWNERS MANUAL FOR INSTRUCTIONS ON LOWERING
THE GAS TANK.
4. Remove the trunk. Cut the carpet at the (4) marked holes. Using a 3/8” drill bit, drill out the (4)
marked spots in the floor.
5. It is recommended to use silicone sealant in any holes drilled in the vehicle to prevent rusting.