Tuffy Security 296 - Manual (Page 2)

Page 2 of 3 – 10/23/2012 – Rev 10/23/12
***Note: Some TJ vehicles may not feature the #5.4.2 floor mounted seat brackets, but should feature the center seat
belt bracket and bolt. If desired, the two outer mounting holes may be drilled and bolted down with hardware not
included.
FIGURE 1
5. The #4.4 and #4.5 Rubber Edge Trim were installed at the factory, however if any pieces have become dislodged
during shipping, re-install these at this time. Install the #4.4 Long Rubber Edge Trim onto the rear edge of the #1 Lid.
Install the (2) #4.5 Rubber Edge Trim pieces onto the #1 Lid left and rights sides, as illustrated. (Figure 2)
FIGURE 2
6. Install the #1 Lid with trim pieces into the vehicle by positioning the rear edge side tabs under the hardtop mounting lip
at the rear of the vehicle body and tilting the Lid downwards to meet up with the #2 Front Panel. The #1 Lid is
intended to lap over the front of the #2 Front Panel. (Figure 3)