Toa C-CC774 - Manual (Page 12)

12
SUMMER TIME
OFF /ＯＮ/SET
- FIRST DAY/LAST DAY
Enables summer time between 2:00 AM on the set first day of summer time
and 2:00 AM on the last day.
OFF: Disables summer time.
ON : Enables summer time.
SET: Performs summer time setting.
MANUAL
ZOOM SCALABLE
P/T
ON /OFF
Rotation speed relative to zoom ratio can be set to OFF. Select OFF when
the function of reducing the rotation speed during telescopic operation is not
needed.
P/T LIMIT OFF /ON/CLEAR
Designate the pan and tilt rotation range limits.
OFF : Disables rotation limits.
ON : Enables rotation limits.
The camera does not tilt between –90°and –185°.
CLEAR: Deletes all rotation limit positions.
P/T LIMIT SETTING LEFT /RIGHT/UP/DOWN Set the pan and tilt rotation range.
MAX P/T SPEED
120 /160/240/360/A/8/16/24/
40/60/90
Set the maximum speed of panning and tilt in manual operation.
The larger the figure is, the faster pan and tilt speeds.
“
A” : Operates at a constant speed of “25” without acceleration or
deceleration.
FLIP OFF /AUTO/MECHANICAL
This function flips the image shown on the monitor when the camera stops
executing a tilt operation (rotating the camera vertically) between –90° to
–185°. (Factory default : OFF)
OFF : Turns the Flip function off.
AUTO: Turns the Flip function on.
MECHANICAL: Turns the Mechanical Flip function on. This function flips the
image shown on the monitor by rotating the camera 180°in the panning
direction while its tilt operation (rotating the camera vertically) is going on at
the range of –90°.
UP LIMIT ON /OFF
When the camera’s vertical rotation is set to horizontal (0°or –180°) with the
joystick, the camera’s case may appear at the top of the screen, causing a
dark patch. Setting this switch to the ON position limits the tilt angle, as
shown at right, and reduces the amount of case visible onscreen. (Factory
default : ON)
MAINTENANCE
INITIALIZE NO /YES
In the combination camera’s preset memory playback function, a stepping
motor is controlled by open loop. Therefore, if the camera is used for long
uninterrupted periods of time, the camera position may deviate from the
original settings. In such cases, deviation can be corrected with
re-initialization.