Toa DP-K1 - Manual (Page 67)

67
Step 8. If the unit with its ID duplicated is detected, change
the unit ID.
(1) Select the unit for which you want to change the
ID, then press the [Modify Unit ID] button.
Unit ID setting screen is displayed.
(2) Select the corrected unit ID, then press the [OK]
button.
Unit ID is changed.
Step 7. Press the [Next] button, then the Check Unit ID
screen is displayed.
Note
If the unit ID is duplicated, the corresponding units
cannot be controlled with this setting software.
Change the settings (Step 8) so that unit ID is
unique.
Tip
Unit ID is factory pre-set to "1."