Toa DP-K1 - Manual (Page 34)

34
(5) Compressor threshold button [Compressor Threshold (dB)]
Displays the compression threshold level for each channel by means
of numerical values. If you press this button, a dialog for threshold
level setting is displayed, enabling you to set the level by directly
entering a numerical value. (Setting range: –16 to +24 dB)
The Up and Down buttons located on the right side can also be used
to change the threshold level in 1 dB units.
(6) Compressor ratio button [Compressor Ratio]
Displays the compression ratio for each channel by means of numerical values. If this button is pressed,
setting values can be selected from the pull-down menu. The Up and Down buttons located on the right
side can also be used to change the value.
(7) Compressor sync button [Compressor Sync]
Displays the ON/OFF setting status of the compressor sync function for each channel. Press this button
to determine whether (ON) or not (OFF) to use the compressor sync.
(8) Compressor attack button [Compressor Attack (ms)]
Displays the compression attack time for each channel by means of numerical values. Pressing this
button permits setting values to be selected from the pull-down menu. The Up and Down buttons located
on the right side can also be used to change the value.
(9) Compressor release button [Compressor Release (ms)]
Displays the compression release time for each channel by means of numerical values. Pressing button
permits setting values to be selected from the pull-down menu. The Up and Down buttons located on the
right side can also be used to change the value.
(10) Gate threshold button [Gate Threshold (dB)]
Displays the noise gate threshold level for each channel by means
of numerical values. If you press this button, a dialog for threshold
level setting is displayed, enabling you to set the level by directly
entering a numerical value. (Setting range: –∞ to –26 dB) You can
also change the threshold level in 1 dB units with the Up and Down
buttons located on the right side.
(11) Gate attack button [Gate Attack (ms)]
Displays the noise gate attack time for each channel by means of numerical values. Pressing this button
permits setting values to be selected from the pull-down menu. The Up and Down buttons located on the
right side can also be used to change the value.
(12) Gate release button [Gate Release (ms)]
Displays the noise gate release time for each channel by means of numerical values. Pressing this button
permits setting values to be selected from the pull-down menu. The Up and Down buttons located on the
right side can also be used to change the value.
(13) Gate-status indicator
While the Noise Gate is working, the Gate-status indicator lights blue.