Toa FS-7000 SERIES Installation - Manual (Page 35)

35
6.5. 2-Channel Broadcasts
To provide 2-channel priority/background music broadcasts, first add a BGM player and power amplifiers to
the basic system configuration, then perform the wiring described on the next page. Select BGM broadcast
zones using the FS-7000JP's BGM Zone Selector Keys.
See page 57 regarding the connection of BGM player.
[System Operation]
• Broadcasts can be made to up to 10 selected zones.
• Background music and announcements using the CP microphone can be broadcast simultaneously to
different zones.
• Zones to which announcements are broadcast from the CP microphone are selected at the FS-7000CP.
• BGM broadcast zones are selected at the FS-7000JP.
• Selecting zones in which BGM broadcasts are in progress at the FS-7000CP interrupts the BGM broadcasts
in those zones, allowing announcements from the CP microphone to be heard instead.
[Notes]
• Only 1 piece of the FS-7006PA or FS-7012PA can be connected to each of the FS-7000JP's Priority Input
and BGM Input. Never connect 2 or more units to these terminals, as the excessive load could cause the
amplifier to fail.
• The FS-7000JP's maximum output per speaker line varies depending on the connected power amplifiers.
Maximum power output is 500 W when the FS-7012PA is connected, and 280 W when the FS-7006PA is
connected. If the load capacity exceeds the maximum power output, divide speaker lines into 2 or more
lines.
• A 0.5 A fuse is preinstalled by the factory for speaker line protection. Depending on the total wattage of all
the connected speakers on a line, replace the fuse with one having the correct rating. (See page. 29.)
[Settings]
Set the FS-7000CP's Output Mode Setting switch to the "2-CH" position.