Solvline SerialGate - Manual (Page 20)

SerialGate User Guide
20
SG-1010W/ALL Exterior
SG-1010W/ALL (Rear)
SG-1010W/ALL (Front)
SG-1010W/ALL

LED: Operation status of SerialGate. Next section describes the meaning of each
LED display status.

LAN port: 8-pin RJ45 jack which is used when connecting SerialGate to networking
devices such as Ethernet card, hub, and router.

Terminal block power connector: for connection of terminal block power cable

Power connector: for connection of DC 12V adapter cable
Terminal Block and DC Adapter Jack connect different power at the sa
me time power is applied at the same time as it may cause irreparabl
e damage to the product, if you do not!

Serial: DB9 for RS-232 and 5P Terminal Block for RS-422/485

Termination Resistor Switch: Selection switch for termination resistor of RS-422/485

Reset: SerialGate reboots if this button is pressed for less than 3 seconds. If pressed
for longer than 3 seconds, SerialGate will restore factory default settings.
SG-1010W/ALL (Left Side)
Reset 버튼