Solvline SerialGate - Manual (Page 15)

SerialGate User Guide
15

Serial Port: RJ-45 socket for serial ports (RS-232 or Combo(RS-422/485))

Power connector: for connection of DC9~30V adapter cable
Terminal Block and DC Adapter Jack connect different power at the sa
me time power is applied at the same time as it may cause irreparabl
e damage to the product, if you do not!

Terminal block power connector: for connection of terminal block power cable

Reset button: SerialGate reboots if this button is pressed for less than 3 seconds. If
pressed for longer than 3 seconds, SerialGate will restore its factory default settings.

LED: Operation status of SerialGate. Next section describes the meaning of each LED
display status.

LAN port: 8-pin RJ45 jack connects SerialGate to networking devices such as Ethernet
card, hub, and router.
SG-1010/232, Combo LED / RESET
LED Status Meaning
PWR
(Red)
On Power supplied to the device
Off No power supplied to the device
LAN
(Green)
Off No active network connection
On Network activated
RDY
(Red)
Blink Normal operation
On System Booting
Off System Error
RS-422 On Serial port set to RS-422 mode (Combo model)
RS-485 On Serial port set to RS-485 mode (Combo model)
Serial
Tx/Rx
Green Blink Serial data transmitted
Orange Blink Serial data received
LAN Port
(Right Orange)
On Network connected
Off Network disconnected
Blink LAN data being transmitted