Reznor RBL Option - Installation - Weather Hood Assembly - Manual (Page 9)

Form I-OPT-WH, P/N 132901 R13, Page 9
Hood Top, P/N
222689
Hood Bottom,
P/N 222692
Right
Side,
P/N 222694
Left
Side,
P/N 222697
STEP 1a) Install top of hood.
- Remove and save screws holding cabinet top.
- Slide edge of hood top under cabinet top.
- Re-insert the screws.
STEP 1b) Attach sides.
STEP 1c) Attach hood bottom.
Use
self-drilling
screws on
sides.
Use self-drilling
screws across the bottom.
Use sheetmetal
screws to
attach top.
Use sheetmetal
screws.
Reuse screws removed from cabinet top. Edge
of hood top MUST BE UNDER the cabinet top.
FIGURE 6A - STEP 1,
Install First Section
Hood Top (2nd Section Piece), P/N 222690
Use sheetmetal screws.
Silicone side seams before
attaching second side section.
Left Side,
P/N 222696 Silicone seam
and use sheetmetal
screws.
Right Side,
P/N 222693
Use sheetmetal
screws.
Use
sheetmetal
screws.
Top Seal, P/N 222691 - Silicone under both
flanges before attaching with screws.
STEP 2a) Install both sides being sure to
silicone before attaching sides.
STEP 2b) Attach top to sides.
STEP 2c) Silicone along top seam and attach
top seal.
FIGURE 6B - STEP 2,
Install Second Section
silicone along the mating surface of the already installed panel. Attach the
second panel piece with sheetmetal screws.
Repeat to attach the other small side panel piece.
b) Install Top Panel - Position the hood top piece over the newly installed side
panels. Attach to the side panels with sheetmetal screws.
c) Install Top Seal - Position the top seal over the seam in the top of the hood. Lift
the seal and silicone along both sides of the seam so that the flanges of the top
seal will be on the silicone. Attach the seal with sheetmetal screws.
3. Install the Filter Supports and Hood Gutters (FIGURE 6C)
a) Install Top Horizontal Filter Support and Clip - Position the top horizontal
filter support inside the top edge of the hood. Line up the holes and attach with
sheetmetal screws.
With the open side down, position the filter clip to the inside of the filter support.
Line up the holes with the support and attach with sheetmetal screws.
b) Install Bottom Horizontal Filter Support and Clip - Position the bottom
horizontal filter support on the bottom of the hood. Attach with sheetmetal screws
Position the filter clip on the filter support and attach with sheetmetal screws.
c) Install Side Gutters - Position the left side gutter on the left side of the cabinet.
Line up the holes and attach with sheetmetal screws. Repeat with the right side
gutter.