Configure firmware, Upgrade firmware, Perform hardware rediscover – RED DSMC FAN 2.0 UPGRADE User Manual
Page 26: Dsmc fan 2.0 upgrade instructions
COPYRIGHT © 2014 RED.COM, INC
DSMC FAN 2.0 UPGRADE INSTRUCTIONS
955-0012, REV-D
|
26
RED recommends that you upgrade your DSMC firmware to v4.0.12 or later in order to have full control over
both the top and bottom fans. DSMC firmware v4.0.12 and later offers full hardware support for both fans, and
provides more robust and precise fan settings, so that you have full control over the speed and noise level of
the DSMC fans. Earlier versions of DSMC firmware do not fully support DSMC 2.0 fans.
UPGRADE FIRMWARE
1. Download the v4.0.12 (or later) firmware file for your DSMC from
2. Perform the firmware upgrade on your DSMC BRAIN.
NOTE: For more information on upgrading your DSMC firmware, refer to the
online
at
.
PERFORM HARDWARE REDISCOVER
If you upgraded your firmware before installing the new fans, or if you’re not upgrading your firmware, perform
a manual hardware rediscover after you install new fans so that the DSMC firmware recognizes the new fans.
NOTE: The instructions below are specific to firmware version v4.0.12.
1. Turn on your DSMC.
2. Go to Menu > Settings > Maintenance.
3. Select Rediscover.
4. Select Yes to perform the hardware rediscover.
Wait for the DSMC BRAIN to shut down.
5. Power on the DSMC BRAIN.
The DSMC firmware rediscovers all hardware and caches the data for future boot cycles.
Hardware Rediscover
04
CONFIGURE
FIRMWARE