RED DSMC FAN 2.0 UPGRADE - Manual (Page 11)

DSMC FAN 2.0 UPGRADE INSTRUCTIONS
COPYRIGHT © 2014 RED.COM, INC 955-0012, REV-D | 11
INSTALL 2.0 BOTTOM FAN
NOTE: If any of the fan bumpers fall off of the fan assembly during the installation process, reattach the bumpers
and ensure that they are properly aligned.
1. Identify the new fan assembly.
2. Align the female connectors with the pins in the connector slot and verify the following:
‒ Verify that the blue wire is at the top, and the red wire is at the bottom.
‒ Verify that the connector enters the slot directly, and NOT on its side, so that the female connectors
align with the pins in the connector slot.
3. Carefully push the white connector into the appropriate slot on the DSMC BRAIN, using the ESD-safe sol-
der stick for assistance if necessary.
You will hear a click when the connector is successfully attached to the BRAIN.
Connect Fan