RED DSMC FAN 2.0 UPGRADE - Manual (Page 23)

DSMC FAN 2.0 UPGRADE INSTRUCTIONS
COPYRIGHT © 2014 RED.COM, INC 955-0012, REV-D | 23
INSTALL TOP FAN AND DSMC TACTICAL TOP PLATE 2.0
NOTE: The top plate installation instructions below are also applicable to the original DSMC TACTICAL TOP
PLATE that was modified by RED to accommodate the top fan.
1. Ensure that the original TACTICAL TOP PLATE and exhaust fan pogo cover are already removed from the
DSMC. For more information on removing the TACTICAL TOP PLATE and exhaust fan pogo cover, go to
“Remove DSMC TACTICAL TOP PLATE” on page 20 .
2. Place the DSMC BRAIN on a suitable flat work surface with the top of the DSMC facing upward.
3. Place the top fan assembly on top of the vent so that the “RED PRO” lettering is facing up and the con-
nector is facing down.
4. Attach the top fan to the DSMC BRAIN by installing two (2) M2x0.4 x 4 mm cap screws (included) with a T6
Torx driver (included). DO NOT FULLY TIGHTEN.
5. Tighten the M2x0.4 x 4 mm cap screws evenly. DO NOT exceed 30 in-oz, or damage may occur.
WARNING: DO NOT OVERTIGHTEN.
Insert Top Fan
Install Top Fan