Maintenance tools 3.0, Minimum proheat service tools, Minimum standard hand tools – Proheat M80 User Manual
Page 30: Notice
PROHEAT G-I PCM SERVICE MANUAL
3-1
MAINTENANCE TOOLS
3.0
The following list is the minimum recommended tools to properly service the
M-Series. Please refer to the M-Series parts book at www.proheat.com for
additional PROHEAT service tools and computer software.
Minimum Proheat Service Tools
1.
Remote Start Switch (P/N PK0091)
2.
Temperature Sensor (P/N 200302K for G-I PCM)
3.
Test Gauge, Air Pressure Digital Manometer (P/N PK0036)
4.
Test Gauge, Air/Fuel Pressure (P/N PK0067)
5.
Test Gauge Adaptor (P/N PK0091)
Rotary Vane Compressor Models ONLY (SN 600000 to 699999)
Minimum Standard Hand Tools
•
Digital Multimeter
•
Ratchet – 3/8" drive
•
Extension, 12" – 3/8" drive
•
Socket, 13 mm – 3/8" drive
•
Screw Driver, Flat Blade 1/4" blade
•
Allen Key, 4 mm – 3/8" drive or extension T-handle
•
Allen Key, 5 mm – 3/8" drive or extension T-handle
•
Allen Key, 9/64"
•
2x Combination Wrench, 3/4"
•
Combination Wrench, 5/8"
•
Combination Wrench, 9/16”
•
Combination Wrench, 7/16”
•
Wire Brush
•
Adjustable Wrench
•
Vise Grip
•
Torque Wrench 25 – 150 in. lbs. [2.8 – 17 Nm]
NOTICE
Additional standard hand tools may
be required. This list is not intended
to be exhaustive.