PRG Bad Boy User Manual 1.6 - Manual (Page 80)

72 BAD BOY ® SPOT LUMINAIRE USER MANUAL
Replacing the Lamp
Parts:
71.2566.1200.0 1 EA LAMP, FASTFIT, PHILIPS MSR GOLD™
Tools:
Cotton gloves or finger cots
WARNING: Remove power from luminaire before performing any maintenance procedures.
CAUTION: Refer to "Proper Lamp Servicing and Operation" on page 61 before handling the lamp.
To replace lamp:
Step 1. Remove power from lamp and allow lamp to cool for at least 5 minutes.
Step 2. Remove power from luminaire.
Step 3. At rear of luminaire, rotate backcap counter-clockwise to remove (it will still be connected by a tether). Refer
to Figure 4-8 on next page.
Step 4. Remove existing lamp by rotating lamp base counter-clockwise and pulling straight out of backcap.
Step 5. Position new lamp as shown in Figure 4-8 DETAIL A and insert into rear bulkhead. Rotate 45 degrees
clockwise to lock in place. You will hear a click when properly seated.
Step 6. Replace backcap.
Step 7. Reset Lamp Hours. (Refer to "Lamp Screen" on page 38.)
Step 8. Optimize lamp. (Refer to "Adjusting the Lamp" on page 74.)