PRG Bad Boy User Manual 1.6 - Manual (Page 42)

34 BAD BOY ® SPOT LUMINAIRE USER MANUAL
MENU SYSTEM
Using the Menu Touchscreen
The menu system is a set of software screens used to configure, address, report status, and test the luminaire. These
functions are controlled at the Menu Touchscreen as shown in Figure 3-1.
Figure 3-1: Menu Touchscreen
Color Codes
The menu screens are color coded as follows:
+ Blue - function control screens. These are configurable functions which will open a sub-menu when touched.
+ Green - informational screens. These display status info and will not open further menus when touched.
+ Red - important control screens. These are configurable functions which will open a sub-menu when touched.
Activating these functions will affect important luminaire settings.
Navigation
To navigate the menus, press the blue or red areas of the touchscreen.
Screen Saver Mode
The menu will automatically return to the Home screen, from a sub-menu, if inactive for 45 seconds. The display will
go into screen saver mode (backlight off) if inactive for five minutes.
The menu will automatically jump to the Status screen and wake up the display when a mechanism status changes
(error, calibration, etc.).
Bypass Calibration
If the menu screen is touched (in the center) and held during startup, the luminaire will present a menu that provides
the option to bypass calibration. This feature allows the luminaire to skip the calibration sequence so that it can be
powered up in the case for configuration purposes. (Refer to
"Bypassing Calibration" on page 26.)
On-Board Battery
The luminaire contains an on-board battery so that it can be addressed and configured without being connected to
main power.
Some Bad Boy luminaires also have a Battery Wake Switch located below the Comm LED. This momentary switch
will engage the on-board battery. While the switch is depressed, the menu interface comes up allowing you to set the
DMX address and other configuration changes without applying power to the unit. The motorized functions are
automatically disabled when under battery control.
CONFIG
addr 043
univ A
1400w
ETHERNET
COMM
IN
DMX
THRU
15A Max
AC IN
200 -240 VAC
50 / 60 Hz
LAMP
hrs 125
temp 34C
INFO
01:34
TEST
COMM
DMX
STATUS
OK
IS POW ERED
ACTIVE ON LY
WHEN FIXTURE
Menu Touchscreen -
Used to configure
luminaire address
and other options.
Also, provides status
information and
testing.