PRG Bad Boy User Manual 1.6 - Manual (Page 72)

64 BAD BOY ® SPOT LUMINAIRE USER MANUAL
Removing the Enclosure Covers
To access interior enclosure components, one or both of the Upper Enclosure Covers may need to be removed.
Parts:
21.9812.0820 1 EA ASSY, INTAKE COVER, UPPER ENCLOSURE
21.9812.0830 1 EA ASSY, EXHAUST COVER, UPPER ENCLOSURE
Tools:
#2 Philips screwdriver
To remove Upper Enclosure Covers:
Step 1. At Upper Enclosure Cover, loosen two captive screws.
Step 2. Remove cover by pulling straight out until lip clears yoke support.
CAUTION: The Upper Enclosure Covers are not identical. One is for the Intake side and one for the Exhaust
side. Be sure to re-install covers in the proper location.
Figure 4-3: Removing Upper Enclosure Covers
Intake Cover
Exhaust Cover
Captive Screw (2)
Mesh Screen
PRG Sticker