PRG Bad Boy User Manual 1.6 - Manual (Page 62)

54 BAD BOY ® SPOT LUMINAIRE USER MANUAL
Mechanism Errors
Errors will be shown after the mechanism code, for example: PAN:Comm Error.
Error Code Explanation Solution
Comm Error Error communicating with motion processor
Check CAN cables/connections,
motor control board
Init Error Error during initialization of motion processor
Check CAN cables/connections,
motor control board
Cal Error
Error resetting position values in motion
processor at beginning of calibration Check CAN cables/connections,
motor control board
Cal Timeout
An action during calibration took longer than
expected Check CAN cables/connections,
motor control board
No Stop
Mechanism which calibrates to a physical
stop did not find that stop
Check mechanism
Sensor Stuck
During calibration, could not find either edge
of the sensor or the sensor did not turn off as
expected
Check for mechanism motion,
sensor operation
No Sensor
During calibration, no sensor was found in
the range of travel Check for mechanism motion,
sensor operation
Hall Sensor Edge Found sensor, but couldn't find far edge
Check for mechanism motion,
sensor operation
Motion Error
Mechanism's actual position is too far from
its commanded position
Check mechanism motion
Command Error
Error while sending commands to the motion
processor Check CAN cables/connections,
motor control board
Get Position Error
Error when retrieving current position from
motion processor Check CAN cables/connections,
motor control board
Spin Error
Error while sending spin command to motion
processor Check CAN cables/connections,
motor control board
Stop Spin Error
Error while sending stop spin command to
motion processor Check CAN cables/connections,
motor control board
Spin Stop Timeout
Spinning mechanism did not come to rest in
the given period Check CAN cables/connections,
motor control board