PRG Bad Boy User Manual 1.6 - Manual (Page 28)

20 BAD BOY ® SPOT LUMINAIRE USER MANUAL
Vertical "Yoke Out" Hang
The Bad Boy Spot Luminaire can be hung in a vertical position, if required. In this configuration, the luminaire should
be positioned so that the interface panel (display) is facing downward for ease of programming.
WARNING: The luminaire is heavy. Use caution when lifting.
WARNING: The vertical configuration requires 3 people to hang and secure the luminaire.
WARNING: Two safety cables and at least two truss hooks should be used in all hang configurations.
To install in vertical hang:
Step 1. Orient Hanging Brackets as shown in Figure 2-6.
Step 2. Place Hanging Bracket down over buttons and slide until bracket locks into place (you will hear a "click"
when bracket is locked).
CAUTION: Hanging Brackets must be installed in the orientation shown in Figure 2-6 so that the interface
panel (display) will face downward.
Figure 2-6: Attaching Hanging Brackets
Step 3. Roll case to mounting location as required (Figure 2-7).
Step 4. Using two people, carefully lift luminaire into mounting position so that display is facing downward .
Step 5. Using a third person, secure in place by tightening Truss Hook wing bolts. Ensure that luminaire is fully
supported.