Canon FAX-L400 - Manual (Page 41)

4-8
Memory Sending
The machine begins calling the other party and transmitting the information after all documents are scanned into
the memory.
Since the machine is multitasking, you can perform other operations while the machine is sending a fax.
The machine has enough memory to store up to approximately 256 pages* (fewer if the document contains many
graphics or particularly dense text).
* Based on Canon FAX Standard Chart No. 1, standard mode.
• When a large amount of memory is used, MEMORY FULL may be displayed depending on the
documents to be sent, and the machine can neither store the scanned documents in memory nor send
them. In this case, print or delete any documents in memory, or select a lower fax resolution such as
STANDARD
, then send the documents.
■ Using the ADF
1 Press FAX to set to Fax mode.
Ex:
2 Prepare the document and load it face up in the ADF. (
→ User’s Guide)
(Standby to scan)
• To adjust the resolution
→ pp. 4-1, 4-2.
• To adjust the scanning density
→ p. 10-4.
3 Dial the other party’s fax number.
Ex:
• For dialling methods
→ p. 4-3.
• If you enter the wrong number, press Stop/Reset
→ enter the correct number.
• If you make a mistake, press 4 (–), or press Function
→ Delete to delete the last number. Or press
Function
→ Clear to delete all numbers you entered → enter the correct number.
• When you have to first dial a digit to get an outside line (“9”, for example), add a pause after that digit by
pressing Redial/Pause.
TEL= 9057951111
DOCUMENT READY
03/12 2002 TUE 15:11
FaxOnly
STANDARD
NOTE
Sending Methods