Timer registers, 1 registers, 1 free running counter – Cypress enCoRe CY7C63310 User Manual
Page 43
CY7C63310, CY7C638xx
Document 38-08035 Rev. *K
Page 43 of 83
16. Timer Registers
All timer functions of the enCoRe II are provided by a single timer block. The timer block is asynchronous from the CPU clock.
16.1 Registers
16.1.1 Free Running Counter
The 16 bit free-running counter is clocked by the Timer Capture Clock (TCAPCLK). It is read in software for use as a general purpose
time base. When the low order byte is read, the high order byte is registered. Reading the high order byte reads this register, allowing
the CPU to read the 16-bit value atomically (loads all bits at one time). The free-running timer generates an interrupt at 1024
μs rate
when clocked by a 4 MHz source. It also generates an interrupt when the free running counter overflow occurs every 16.384 ms (with
a 4 MHz source). This allows extending the length of the timer in software.
Figure 16-1. 16-Bit Free Running Counter Block Diagram
Tim er C apture
C lock
16-bit Free
Running Counter
O verflow
Interrupt/W rap
Interrupt
1024µs Tim er
Interrupt
Table 16-1. Free Running Timer Low order Byte (FRTMRL) [0x20] [R/W]
Bit #
7
6
5
4
3
2
1
0
Field
Free running Timer [7:0]
Read/Write
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Default
0
0
0
0
0
0
0
0
Bit [7:0]:
Free running Timer [7:0]
This register holds the low order byte of the 16-bit free running timer. Reading this register causes the high order byte to be
moved into a holding register allowing an automatic read of all 16 bits simultaneously.
For reads, the actual read occurs in the cycle when the low order is read. For writes, the actual time the write occurs is the cycle
when the high order is written.
When reading the Free Running Timer, the low order byte must be read first and the high order second. When writing, the low
order byte must be written first then the high order byte.
Table 16-2. Free Running Timer High-order Byte (FRTMRH) [0x21] [R/W]
Bit #
7
6
5
4
3
2
1
0
Field
Free-running Timer [15:8]
Read/Write
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Default
0
0
0
0
0
0
0
0
Bit [7:0]:
Free-running Timer [15:8]
When reading the Free-running Timer, the low order byte must be read first and the high order second. When writing, the low
order byte must be written first then the high order byte.