Cisco WIP310 - Manual (Page 18)

Chapter 2
Installing the WIP310
14 Wireless-G IP Phone
Select 3 Manual Setup to show the list of configured
wireless networks
Wireless Networks
Use the 4 Up or Down Arrow key to choose the network
you want from the list and press the Select button
The phone displays a message if it successfully
5
connects to the wireless network
Choosing the Wireless IP Settings
By default, your WIP310 phone uses Dynamic Host
Configuration Protocol (DHCP) With DHCP, the router
assigns an IP address to your phone This IP address
assignment is dynamic, meaning that the IP address
assigned to your phone can change
You can configure the phone with a static, or unchanging
IP address
NOTE: You should only configure your WIP310
to use a static IP address if you have been
instructed to do so by your ITSP or by another
support person
To change the wireless IP setting:
In the Home screen, press the 1 Select button to display
the Settings menu Navigate to the Wireless Setup menu
and press the Select button to view your options
Wireless Setup
Select 2 IP Settings and press the Select button
IP Settings
Press the 3 Right Arrow key to choose DHCP or Static IP
If you choose Static IP, enter the following:
Static IP—Enter the permanent IP address to assign to •
your phone
NetMask—Enter the netmask to identify the subnet
•
Gateway—Enter the IP address of your wireless •
router
Primary DNS—Enter the IP address of the primary
•
Domain Name Server (This server translates domain
names to IP addresses )
Secondary DNS—Enter the IP address of the secondary
•
Domain Name Server
Registering Your Phone
After you configure your phone to connect to the wireless
network, your phone must register with your ITSP If you
received your phone directly from your ITSP, it should be
pre-configured and perform this step automatically
If there is a problem with registration, the phone displays
a message that it failed to register If this occurs, contact
your ITSP for assistance