Installing the wip310, Accessing the wireless network, Using wi-fi protected setup – Cisco WIP310 User Manual

Page 13

Chapter 2

Installing the WIP310

Wireless-G IP Phone

Accessing the Wireless Network

The first time you power on the phone, the phone is not

configured to connect to a network To connect your

phone to your wireless network, you need to set up a

Wireless Profile There are two ways to configure the Wi-

Fi Profile: Automatically via Wi-Fi Protected Setup® and

Manually

NOTE:

When configuring the phone’s

wireless network, you should be as close as

possible to the wireless router For normal

use, the phone should be within 300 feet

(90 m) of the wireless network to connect

Using Wi-Fi Protected Setup

If your wireless router supports Wi-Fi Protected Setup, you

can use this option to automatically connect the phone to

your wireless network

NOTE:

Look for the Wi-Fi Protected Setup

button on your router If you are not sure that

your router supports this feature, consult

your router User Guide

Wi-Fi Protected Setup button

The Wi-Fi Protected Setup Mark is a mark of the Wi-Fi Alliance

†

Using the Push Button Method

The easiest way to connect your phone to the wireless

network is the push button method

Press the

Power/End Call button to power on the

phone

Power/End Call button

When the Home screen appears, press the

Select

button to display the Settings menu Press the Select

Button again and navigate to the Wireless Setup

Settings Menu

Press the

Select button to view your options

To automatically configure your profile, navigate to

Use Wi-Fi Protected Setup and press the Select button

Wi-Fi Protected Setup

Navigate to

Connect easily by pushing a button.

Connect Screen

Press the

Select button

Follow the phone’s on-screen instructions to connect

your phone to your network using Wi-Fi Protected

Setup: