Cisco VIDEO CAMERA OL-20862-01 User Manual
Setting up the cisco unified video camera, Configuring the cisco unified video camera
C H A P T E R
5-1
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.0 (SIP)
OL-20862-01
5
Setting Up the Cisco Unified Video Camera
The Cisco Unified IP Phone 9951 and 9971 supports the add-on accessory Cisco Unified Video Camera.
The Cisco Unified Video Camera connects to your Cisco Unified IP Phone and allows you to make a
point-to-point video call with another Cisco Unified IP Phone with a Cisco Unified Video Camera
attached. If a phone does not have a Cisco Unified Video Camera attached, it can only receive one-way
video.
This chapter contains the following information:
•
Configuring the Cisco Unified Video Camera, page 5-1
•
Attaching the Cisco Unified Video Camera, page 5-2
•
Adjusting the Camera Settings, page 5-2
•
Post-Installation Steps, page 5-4
•
Using the Cisco Unified Video Camera, page 5-4
Configuring the Cisco Unified Video Camera
To configure the Cisco Unified Video Camera, you must perform the following configuration steps in
Cisco Unified Communications Manager administration:
Note
The parameters described in the following procedure can be enabled on either the Phone Configuration
window (Device > Phone), the Enterprise Phone Configuration window (System > Enterprise Phone
Configuration), or the Common Phone Profile window (Device > Device Settings > Common Phone
Profile). Be sure to also check the corresponding Override Common Settings parameter in the
configuration window. The Phone Configuration window is referenced below for purposes of the
procedure description.
For more information about parameters that can be configured in any of these three configuration
windows, see the
“Configuring Product Specific Configuration Parameters” section on page 8-20
.
Procedure
Step 1
In the phone configuration window (Device > Phone) of the phone to which you are adding the Cisco
Unified Video Camera, enable the Cisco Camera parameter. This field is located in the Product Specific
Configuration layout portion of the window.