LABEC M-MIA-A - Manual (Page 41)

Ultrasonic milk analyser
Serve for choosing special (technological) working modes. After starting it the
following appears on the display:
Special modes
Calibration
Cycle
Exit
This mode is normally used in production conditions.
7.2.1.2. Calibration mode
In mode Calibration the analyzer is ready to make measurement and to send
the received results towards the technological milk analyzers calibration
system. For this purpose you need personal computer type IBM PC,
company’s calibration system LSC.EXE and methods for calibration of milk
analyzers (see the corresponding documents). To start measurement in this
mode, the operator has to put a sample-holder containing milk sample in the
recess of the analyzer and to press the button Enter.
7.2.1.2. Cycle mode
Mode Cycle serves for training the analyzers. When you start this mode, the
analyzer, without additional commands, sucks the sample, makes the
measurement, pours the sample out in the sample-holder and displays the
received results cyclically.
7.2.2. Corrections
Serves for entering corrections in the measured data. Detailed description in
point 6.3.2 and 6.3.3.
7.2.3. Settings.
Serve for assigning different working parameters (modes).
7.2.3.1. Net number.
Serves for assigning the device network number when connecting it in the
production network. The possible numbers are from 0 to 15 including.
After starting this function the display shows the following:
Net number
0
- OK +
Operation manual MRC.VER.01-02.10