KERN & SOHN ABJ 320-4NM - Manual (Page 37)

ABS-N_ABJ-NM-BA-e-1312 37
10.7.1 Freely programmable weighing unit
Call up menu

In weighing mode press the UNIT key for 3 sec. Use the
navigation buttons ( ) to select „UNIT.U“. The
current setting is marked by the stability display ( ).
With stability display ( ) Unit enabled
Without stability display ( ) Unit disabled
if necessary enable units

Press TARE
Enter conversion factor
1. Press TARE and current setting will be displayed.
2. Use the navigation buttons to enter the desired
conversion factor (see chapter 3.1.1 „Numeric input“).
3. Press ON/OFF repeatedly or for 3 sec., the balance will
return into weighing mode
How to change weighing units
 To return to the previously enabled weighing units go to weighing mode by
UNIT
.
• With a numeric input of the conversion factor, the position of the decimal
dot can be changed, see chpt. 10.7.2
• For the freely programmable weighing unit, no unit symbol will appear in
the display.