Culligan Platinum Plus Series - Manual (Page 26)

22
Programming
(cont.)
• Salt Dosage - This setting is used to set the salt dosage. The display will first show
“dOSAGE” for two seconds and then display the default (or previously programmed value).
The proper units (lbs or kg) will appear according to dip # 7 setting (English/Metric). Adjust
the salt dosage with the “Up” or “Down” keys.
Pressing the “Program” key will save the setting and move to the next programming step.
• Cycle 1 Time - This setting is used to program the
cycle 1 time that is usually backwash. The time of the
cycle is kept in minutes. The display will show the
“BACKWASH” and “MINS” icons and the cycle time
in the right most digits. Adjust the value with the “Up”
or “Down” keys.
Pressing the “Program” key will save the setting and move to the next programming step.
• Cycle 2 Time - This setting is used to set the time in
minutes for cycle 2. This cycle is brine draw / slow
rinse for softeners. The display will show the “BRINE
RINSE” and “MINS” icons and the cycle time in the
right most digits. Adjust the value with the “Up” or
“Down” keys.
Pressing the “Program” key will save the setting and move to the next programming step.
• Cycle 3 Time - This cycle is the Fast Rinse for
softeners. The display will show the “Fast Rinse” and
“Mins” icons and the cycle time in the far right digits.
Adjust the value with the “Up” and “Down” keys.
Pressing the “Program” key will move to the next
programming step.
• Cycle 4 Time - This cycle is the Refill for softeners.
The display will show the “Refill” and “Mins” icons
and the cycle time in the far right digits.
Pressing the “Program” key will move to the next
programming step.
KG 3.O
Note: This setting also appears during Aqua-Sensor ® Programming.
Note: This setting also appears during Aqua-Sensor ® Programming.
Note: This setting also appears during Aqua-Sensor ® Programming.
Note: This setting CAN NOT be adjusted!