Assemble recording technique — 1, Assemble recording technique — 2, Assemble recording technique — 3 – Philips VKR 6865 User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Assemble recording technique — 1

(To replace the battery pack during recording)

If the battery v/arning appears in the viewfinder or the LCD

display while recording, stop recording by sliding the POWER

switch to OFF, not the STOP button.

Replace the battery pack with a charged one.

Slide the POWER switch to ON.

• The unit will be in the Recording Standby mode.

Press the recording start/stop button to start recording.

Assemble recording technique — 2

(To search for the assemble point with the “Retake” function)

Alter reviewing a recorded segment, you may decide to re-record it

immediately. The Retake function is convenient for this.

Make sure the Camcorder is in the Recording Standby mode.

(If not. engage the mode.)

Press either REW/FF button to reach the point where you

wish a new recording to start. When the REW/FF button is

released the Camcorder will enter the Recording Standby

mode again.

Press the start/stop button to start recording.

Assemble recording technique — 3

(To recorcf onto a partially recordecf tape)

Play back the tape to a point where you wish a new

recording to start.

• Use the PICTURE SEARCH button for faster location.

Press the PAUSE/STILL button at the located point.

• The unit will enter the Still mode.

Press the REC standby button.

• The unit will enter the Recording Standby mode.

Press the Recording start/stop button to start recording.