Philips CCB 134AT - Manual (Page 8)

S Turning On the TY/VCR
Before you turn on the TV/VCR, make sure batteries are in the
remote control and theP//VCR is hooked up correctly.
The instructions on this page work only when you turn on the
TV/VCR for the first time.
I
Press the COMBI button, then press the POWER button.
TheTVA^CR will come on and the screen shown below will appear.
SELECT LANGUAGE
> ENGLISH ON
ESPAÑOL
SELECT AT OR
PRESS MENU TO CONTINUE
2
Press the PLAY/ a button or the STOP/T button to select
Engtfsh or Spanish on-screen displays and menus.
3
Press the MENU button. The screen shown below will appear.
CONf'ia ANTTBSINA Oft CABLE
TOTVCR
THEN PRESS ►
TO END PRESS EXIT
4
5
Use the CH(annel) .A./V button or the Number buttons
on the remote control to select aTV/VCR channel. Use
theVOL(ume) ¿cs/v button to adjust the sound.
Press the F.FWD/^ button to begin automatic channel
setup.
The TV/VCR will memorize all available channels. When
channels are set, CHANNELS ARE SET will appear on the screen
briefly. Then the TV/VCR will go to the lowest channel pro­
grammed.
(If you try to set up channels when there is no antenna or cable
connected to the TV/VCR, programming will appear to take place,
but eventually a NO TV SIGNALS ... message will appear on the
screen. Connect an antenna or cable to the ANT(enna) jack on the
TV/VCR, then press the F.FWD/^ button again.You may need to
follow the steps on page 10 instead.)
r“5
4
Helpful Hints
If you do not see any on-screen dis­
plays when you turn on the TV/VCR,
check your hookups, then try again.
If you still do not see any on-screen
displays, follow the steps on pages
nine-10 to select a language and
set up channels.
To skip step 2, press the MENU
button. All on-screen displays will be
in English. To skip step 4, press the
STATUS/EXIT button. Channels will
not be set up, and CHANNELS NOT
SET will appear on the screen
briefly.
You cannot set up channels if you
are using a Cable Box.
Line Input mode will always be
stored in the TV/VCfCs memory as
channel 00. When you se/ect chan­
nel OO.A/V IN will appear on the
screen briefly. Press the CH(annel)
/s/s7 button or the Number but­
tons to select another channel.