Philips CCB 134AT - Manual (Page 5)

Before Using the TVIVCR 5
Putting Batteries in the Remote Control
I
Remove the battery compartment ltd on the bottom of
the remote control by pressing in the tab, then pulling up
the lid.
2
Place three AA batteries inside the battery compartment
with their + and - ends aligned as indicated.
3
Replace the battery compartment lid.
1
2
3
Erasure Prevention
Video cassette tapes have record cabs to ensure that recordings
are not accidentally erased.
I
To prevent accidental erasure, break off the tab with a
screwdriver.
2
To record again, cover the hole with cellophane tape.
Using the Remote Control
V Point the remote control at the TVA^CR’s remote sensor, then
press the COMBI button when using the remote control to
operate theTV/VCR.. Point the remote control at the Cable
Box/DBS, then press the CABLE/DBS button when using the
remote control to operate the Cable Box/DBS.
* Do not put objects between the remote control and theTV/VCR.
=nC
I
2
TV/VCR Maintenance
» In this TV/VCR, use only tapes with the IVHSI mark.The use of
other tapes may result in poor picture quality and excessive
deposits on the video heads, which may not be covered by the
warranty if damage occurs.
# Make sure any light adhesive stick-on notes are removed from the
video cassette tape before putting the tape in theTV/VCR,
Removable labels like these can jam theTV/VCR.
w Periodic maintenance is required to maintain yourTV/VCR’s excel­
lent performance.This TV/VCR has an automatic head cleaning sys­
tem. However, the video heads will eventually require cleaning or
replacement. Only an authorized service center should perform
this service.
Helpful Hints
The remote control and its batteries
are supplied.
Do not mix alkaline and man­
ganese batteries.
Do not mix old and new batteries.