Philips CCB 134AT - Manual (Page 40)

Follow the steps below to program a timer recording using the
PlusCode programming numbers in your TV guide. Before you
begin, make sure:
«■ The clock has been set. If not, CLOCK MUST BE SET appears.
r Channels are programmed.
There is a tape in theTV/VCR {make sure the tape's record tab
is intact and the tape is long enough to record the program).
i You have completed the steps on pages 38-39.
Complete each step within 60 seconds of completing the
previous step. If you don’t, you may return to step I.
40 Timer Recording With the VCR Pius+ Programming System
Press the COMBI button, then press the VCR
PLUS+/ENTER button.
^CR PLUS+ PROGRAM
PLUS CODE ■ --------------
\^0 END PRESS EXIT
y
2
Press the Number buttons to enter the PlusCode pro­
gramming number of the program you wish to record
{this
number is different for every program). Finally, press the VCR
PLUS+/ENTER button.
VCR PLUS+ PROGRAM
PLUS CODE 89687----------
TO SET PRESS VCR *
TO CORRECT PRESS CLEAR
^ TO END PRESS EXIT
3
Press the PLAY/A button or the STOP/T button to select
a ONCE, DAILY, OR WEEKLY recording.Then, press the
F.FWD/^ button.
• ONCE:
The VCR will record a TV program on any day you
choose, up to 12 months away.
DAILY: The VCR will record every day from Monday to Friday -
starting at the same time and recording for the same length of
time,
® WEEKLY: The VCR will record on the same day. at the same
time, and for the same length of time every week.
/ VCR PLUS* PROGRAM \
>ONCE
DAILY (MON . FRI)
WEEKLY
SELECT AT CHOOSE ►
TO END PRESS EXIT
3
2
Helpful Hints
You cannot set a timer recording if
DEFEAT RECORDING is set to ON.
Details are on page 33.
If CODE ERROR flashes after you
enter the PlusCode programming
number and press the VCR
PLUS+/ENTER button, the number
you entered wos incorrect (for exam
pie, too short}. If this happens, enter
the correct number.
CLASH may flash on the screen after
you complete step 2. This meons
that the timer recording you just pro­
grammed and another timer record­
ing averiap, and thus the current
timer recording will not be carried
out