Philips CCB 134AT - Manual (Page 59)

Remote Locator 59
YourTVA/CR can find your remote control for you.
When you press the POWER button on theTV/VCR to turn on
theTV/VCR, your remote control beeps and LOCATING
REMOTE appears on the screen.The remote control will beep for
about 30 seconds. Or, press any button on the remote control to
stop the beeping.
If another remote control beeps...
The TV/VCR may find other remote controls. If this occurs, you
can program theTV/VCR to find only its remote control. Follow
the steps below.
1
»n
2
Press the COMBI button, then press the MENU button.
Press the PLAY/A button or the STOP/V button to select
PRIM. SETUP, then press the F.FWD/^ button.
3
Press the PLAY/A button or the STOP/T button to select
REMOTE LOCATOR, then press the F.FWD/^ button.
PRESS MUTE THEN
PAUSE KEY
TO CHANGE CODE FROM 4
TO END PRESS EXIT
4
Press the MUTE button, then press the PAUSE/STILL but­
ton.
YOUR REMOTE LOCATOR
CODE IS 4
PRESS ANY DIGIT
TO CHANGE COOE
TO END PRESS EXIT
Press one Number button (0 - 9) to enter a single-digit code
for your remote control. Your remote control will beep briefly.
If another remote control beeps.
2-3
4
This device complies with part 15
of the FCC Rules. Operation is
subject to the following two condi­
tions: (I) This device may not cause
harmful interference, and (2) this
device must accept any interfer­
ence received, including interfer­
ence that may cause undesired
operation.
rOUR REMOTE LOCATOR
CODE HAS BEEN CHANGED
NEW CODE IS 3
TO END PRESS EXIT
6
Press the STATUS/EXIT button.
Helpful Hint
The vo/ume will be delayed while the
LOCATING REMOTE message
appears on the screen. Press the
STATUS/EXIT button to remove the
message and restore the volume.