Press the combi button, then press the menu button, Press the status/exit button – Philips CCB 134AT User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Setting Up the VCR Plus* Programming System (confd) 39
2
Now, compare the channel numbers you have written in the VCR
PLUS+ CH. and CABLE/TV CH. columns.You’ll notice that some
stations have VCR Plus+ and Cable/TV channel numbers that are
the same, and other stations have channel numbers that do not
match. Where the channel numbers DO NOT match, you must tell
theTVA/CR the VCR Plus+ and Cable/TV channel numbers
according to the following steps.
# Make each entry within 60 seconds of the previous entry.
3
Press the COMBI button, then press the MENU button.
4
Press the PLAY/A button or the STOP/T button to select
VCR SETUP, then press the F.FWD/>- button.
5
Press the PLAY/A button or the STOP/T button to select
VCR PLUS+ RER MAP, then press the F.FWD/^ button*
■^VCR PLUS+ CROSS REF. MAP
VCR PLUS+ CABLE/TV
124
-------
125
-------
01------ --------
02
-----------
03
----
TO SELECT CH PRESS
AT
THEN ENTER CH NO.
V TO END PRESS EXIT
6
Look at the lists you filled in on page 38.
For stations whose
VCR Plus+ and Cable/TV channels do not match, press
the PLAY/A button or the STOP/T button until the arrow
is beside the VCR Plus+ channei you need.Then, press the
Number buttons to enter the corresponding Cable/TV
channel from your list.
Continue this process until you have
entered all the stations on your list.
Note: If you are using a Cable Box/DBS, the Cable/TV channel will
be 03 or 04 (the Cable Box/DBS output channel) for every VCR
Plus+ channel,You must set the Cable Box/DBS to the channel yOu
want to record; leave the Cable Box/DBS on for the timer record
ing.
VCR PLUS+ CROSS REF. MAR
VCR PLUS+ CABLE/TV
I2-*
-------
tlS
-----
01 --------- ► 23
02
---
03
-------
TO SELECT CH PRESS
AT
TO DELETE PRESS CLEAR
TO END PRESS EXIT
2
Examine the lists on
page 38.
Press the STATUS/EXIT button.
To correct a Cable/TV channel num
ber, repeat the steps on this page.
To clear a Cable/TV channel num
ber. repeat steps 3-5 on this page.
Then, press the CH(annel) .¿Vv
button to select it Press the CLEAR
button, then press the STATUS/EXIT
button.
To select line input for the Cable/TV
channel, press 0,0. A/V IN will
appear on the screen.