Document history page – Cypress enCoRe CY7C602xx User Manual
Page 67
CY7C601xx, CY7C602xx
Document 38-16016 Rev. *E
Page 67 of 68
24. Document History Page
Document Title: CY7C601xx, CY7C602xx enCoRe
™ II Low Voltage Microcontroller
Document Number: 38-16016
Rev.
ECN
Orig. of
Change
Submission
Date
Description of Change
**
327601
BON
See ECN
New data sheet
*A
400134
BHA
See ECN
Updated Power consumption values
Corrected Pin Assignment Table for 24 QSOP, 24 PDIP and 28 SSOP
packages
Minor text changes for clarification purposes
Corrected INT_MSK0 and INT_MSK1 register address
Corrected register bit definitions
Corrected Protection Mode Settings in Table 10-7
Updated LVD Trip Point values
Added Block diagrams for Timer functional timing
Replaced TBD’s with actual values
Added SPI Block Diagram
Added Timing Block Diagrams
Removed CY7C60123 DIE from Figure 5-1
Removed CY7C60123-WXC from Section 22.0 Ordering Information
Updated internal 24 MHz oscillator accuracy information
Added information on sending/receiving data when using 32 KHz oscillator
*B
505222
TYJ
See ECN
Minor text changes
GPIO capacitance and timing diagram included
Method to clear Capture Interrupt Status bit discussed
Sleep and Wakeup sequence documented
PIT Timer registers’ R/W capability corrected to read only
Modified Free Running Counter text in section 17.1.1
*C
524104
KKVTMP
See ECN
Change title from Wireless enCoRe II to enCoRe II Low Voltage
*D
1821746
VGT/FSU/AES
A
See ECN
Changed “High current drive” on GPIO pins to “2 mA source current on all GPIO
pins”.
Changed the storage temperature from -40C to 90C in “Absolute Maximum
ratings” section.
Added the line “The GPIOs interrupts are edge-triggered.” in Tables 19-2 and
19-6.
Made timing changes in Table 43.
Added Figure 12-1 (SROM Table) and text after it. Also modified Table 12-1
based on Figure 12-1 (SROM Table).
Changed “CAPx” to “TIOx” in Tables 18-8 and 18-9.
Changed “Capturex” to “TIOx” in Figure 18-3.
*E
2620679
CMCC/PYRS
12/12/08
Added Package Handling information
Formatted code in Clocking section, Removed reference to external crystal
oscillator in Tables 12-2 and 12-4