GTCO Summagrid IV - Users Guide Part 1 - Manual (Page 6)

Summagrid IV 6
2.2 Installing Summagrid IV
2.2.1 Preparing Summagrid IV for Use
1. Connect Summagrid IV to the computer.
Make sure the controller power switch is in the OFF position before connecting
any cables. Then, plug the PC interface cable into the RS-232C port on the
Summagrid IV controller. Attach the other end of the cable into the serial port
on the back of the computer.
NOTE: If the computer has a 9-pin port, use the 9-pin-to-25-pin AT adapter cable
between the interface cable and computer.
2. Attach the power supply.
Plug the power supply into the I/O cable as shown below. Next, join the other
end of the power supply into its rated electrical outlet (110 V, 220 V, etc.). Use
only a Summagrid IV power supply. A substitute could damage the tablet and
would void both FCC certification and warranty.
3. Prepare the stylus or cursor for use.
Depending on the configuration purchased, Summagrid is shipped with either a
stylus, four-button or 16-button cursor. Any of these transducers may be used
corded or cordless, depending on preference.
NOTE: Be certain to power down the tablet before switching transducers.