GTCO Summagrid IV - Users Guide Part 1 - Manual (Page 31)

Summagrid IV 31
1. Insert the Summagraphics Drivers/Utilities diskette into the A: Drive. At the DOS
prompt, type the following: A:[ENTER]
2. Change to the WINDVR directory by typing: CN \WINDVR [ENTER]
3. Run the INSTALL program by typing: INSTALL [ENTER]
The INSTALL program installs the Summagraphics Windows driver and the
SUMMA.EXE control panel program onto the computer. The INSTALL program
prompts for the following information.
 Hard drive where Windows is installed
 Name of Windows directory
 Whether you want to save (by renaming) the previous version of the
drivers or remove them
 Serial communications port to which your graphics tablet is connected
INSTALL then creates a subdirectory called SUMMA under the Windows directory, copies
the drivers and starts the Windows SETUP program.
4. In the Windows SETUP program, at the System Information screen, use the
up/down arrow keys to highlight the MOUSE line and press ENTER.
5. Use the up/down arrow keys to choose OTHER (requires disk provided by
hardware manufacturer) and press ENTER.
6. Type the full pathname of the SUMMA subdirectory under the Windows
directory. Example: C:/WINDOWS\SUMMA [ENTER]
7. Use the up/down arrow keys to select Summagraphics UIOF Wintab Driver and
press ENTER.
8. Accept the new configuration shown on the screen by pressing ENTER.
NOTE: If you’re reinstalling the driver, an anomaly with the Windows 3.1 Setup
program may occur. After selecting the required driver, the Setup program will
prompt again for the location of the driver. To continue, simply re-enter the
driver pathname.