GTCO Summagrid IV - Users Guide Part 1 - Manual (Page 10)

Summagrid IV 10
Preparing the stylus for corded use.
1. Unscrew the cordless endcap. Carefully unplug the lithium battery from its
socket by grabbing the small connector. Be cautious not to pull on the wires
directly.
2. Plug the three-pin connector of the corded endcap into the socket on the front
half of the stylus. Next, screw the corded endcap onto the front half of the
stylus.
3. Plug the stylus cable into the stylus/cursor port on the Summagrid IV controller.
The corded stylus is now ready for use with Summagrid IV. Proceed to step four of these
installation instructions (next page).
CAUTION: The cordless stylus uses a lithium battery as its power source. The battery is
used in this product may present a fire, explosion or chemical burn hazard if mistreated.
Do not recharge, crush, short circuit, disassemble, heat above 100 degrees Celsius (212
degrees Fahrenheit) or expose contents to water. Replacement batteries are available
from Summagraphics. The replacement battery to be used is Summagraphics part number
62-5004-025. Keep the battery in its original package until ready to use. Dispose of used
battery promptly. Do not crush, disassemble or incinerate.