GTCO Summagrid IV - Users Guide Part 1 - Manual (Page 3)

Summagrid IV 3
1.1 Pre-Installation Considerations
1.1.1 Checklist of Equipment
Below is a checklist of the equipment required for a complete Summagrid IV system.
Required Equipment
 Summagrid IV tablet with controller electronics
 PC interface cable
 Power supply
 9-pin-to-25-pin AT adapter cable
 Stylus/Cursor options: three-button stylus, four-button cursor or 16-button
cursor
 Stylus or cursor holder
 Stylus/cursor conversion kit (includes batteries for cordless usage and cables
for corded usage)
 Mounting hardware for stand
Recommended Optional Equipment
 Tablet stand
 Summagraphics Drivers/Utilities Software
1.1.2 Guidelines for Unpacking Equipment
Consider the following guides when unpacking and inspecting the Summagrid IV
equipment.
 Check the cartons received with those listed on the invoice. Report any
discrepancies to the carrier and/or place of purchase.
 Inspect the outside of cartons for signs of damage that may have occurred
during shipping. Report any shipping damages to the carrier immediately.
 Note any positional markings on the carton when removing the equipment.
 Unpack and inspect each piece of equipment for damage and report any
discrepancies to the place of purchase.