GTCO Summagrid IV - Users Guide Part 1 - Manual (Page 23)

Summagrid IV 23
4. If you’re running AutoCAD release 11, select Exit to Main Menu and choose
ENTER.
5. Type Y to save configuration changes and press ENTER.
4.2.5 Using DGPMG.EXP
Below are instructions for installing the protected mode ADI 4.2 driver for AutoCAD
release 11 or 12. These instructions assume the user installed the driver for use
with AutoCAD. If using a different Autodesk product, refer to the specific product’s
documentation for installation information.
4.2.6 Configuring AutoCAD for Use with DGPMG.EXP
AutoCAD Release 11
After installing the ADI 4.2 protected-mode driver, start up AutoCAD and follow the
instructions listed below.
1. Choose Configure AutoCAD from the screen menu. A listing of the current
configuration appears on the screen. Press ENTER to proceed to the
configuration menu.
2. At the configuration menu, choose Configure Digitizer. AutoCAD asks if you
want a new digitizer. Since you’re installing for the first time, type Y and then
press ENTER. A list of digitizer options appear on the screen. Select ADIP386
digitizer and press ENTER.
3. Next, you are prompted for the size of the tablet. A number of options appear
on the screen. Select the number corresponding to the tablet size and press
ENTER.
4. Next, you’re prompted for the type of pointing device (stylus or cursor) that’s
being used. AutoCAD will ask for the number of buttons on the pointing device.
Enter the appropriate number and press ENTER.
5. You’re now asked to name the serial port. Type COM 1 or COM 2 and select
ENTER. If using a computer with a non-standard serial port, specify the IRQ