GTCO Summagrid IV - Users Guide Part 1 User Manual
Page 29

Summagrid IV 29
Only TABLETMG.COM can be relocated. TABLETMG.SYS cannot be relocated. The
user cannot relocate TABLET.COM into another memory area without first removing
the mouse driver by using the TABLETMG/OFF command.
4.3.3 Using TABLETMG.COM
For a Summagrid IV with a 16-button cursor attached to COM 1:
4.3.4 Running the Driver from CONFIG.SYS
Another way to install the driver is by including TABLETMG.SYS as a device driver in
the CONFIG.SYS file. In doing so, the system automatically installs the driver each
time the user boots or turns on the system.
Line Syntax
DEVICE = TABLETMG.SYS [com port] [stylus/cursor] [tracking] [other options]
The command options are the same as for those running TABLETMG.COM from the
DOS prompt or a batch file. Most of the command line arguments described for
TABLETMG.COM also works for TABLETMG.SYS. The exceptions are the /OFF
command and the memory location options /U, /E and /HI.
Example: For a Summagrid IV with a 16-button cursor attached to Com 1:
DEVICE = TABLETMG.SYS /1 /C16
4.3.5 Changing An Installed Driver’s Parameters
Command-line options can be combined together. For example, the user can utilize
both /H and /V together, and it will work in the same way as using /S. Command-
line options can also be issued after the driver is initially installed by running
TABLETMG.COM again. Another example, the user can go back and change the