Chapter 4: user, Enrolling user, Verifying user – FingerTec Face ID 2 (FEM 600) Manual User Manual
Page 14: Adding user information, Deleting user, User
1
4
•
USER
Enrolling User
Face ID can contain up to 00 face images and 3000 fin-
gerprint templates, 10,000 card users. This section cov-
ers user enrollment for face, fingerprint, card and pass-
word.
1. Face Enrollment
One face registration would take approximately 1
minute to completion. The terminal snaps images
from angles of your face and generates a 3 dimen-
sional template for storage. During enrolment on Face
ID, please stand straight and do not move your face
or body, and make sure that your face is calm with
no extreme expression. For height between 10cm to
180cm, recommended distance between Face ID and
user is 0.m.
To enroll face: Press Menu > User icon > Add > User
ID:1 > Insert User ID > Select Face > Follow instruc-
tions from Face ID to complete the enrolment (Make
sure that you look at the camera) > Select Privilege >
Save
2. Fingerprint Enrollment
It is recommended to enroll two fingers for one user
ID. One template is default and another one is used
for backup. You need to check the quality of the fin-
gerprint before doing any fingerprint enrollment. It
is important to locate the center points of the finger be-
cause the center points has to be placed in the middle
of the scanner during enrollment to get a good reading.
You also have to make sure that the fingers are not too
wet or too dry for enrollment.
To enroll fingerprint: Press Menu > User icon > Add >
User ID:1 > Insert User ID > Select Fingerprint > Place
your fingerprint 3 times following instructions given by
Face ID > Select Privilege > Save
3. Card Enrollment
Default card for Face ID is RFID. MiFare and HID card sys-
tems are available upon request.
To enroll card: Press Menu > User icon > Add > User ID:1
> Insert User ID > Select Card > Wave the card at the scan-
ning area until the screen displays the Card ID > Save
4. Password Enrollment
Face ID offers different enrolment methods and password
can be used alone or in combination with other verification
methods. Maximum length of password is 8 digit.
To enroll password: Press Menu > User icon > Add > User
ID:1 > Insert User ID > Select Password > Input password
using the touch keypad > OK > Reconfirm password > OK
> Save