FingerTec Face ID 2 (FEM 600) Manual - Manual (Page 11)

12 CONTENTS
3 • CONNECTION - SYNCING FACE ID
Installations and Communications
At the rear of Face ID, there are connections available for
power and communications.
Back of Terminal
1 USB Port
Linking with USB flash disk for remote data transfer.
2 TCP/IP Port
Connecting with CAT cable for LAN connection, one end
to this port and another to the computer’s TCP/IP Port.
TCP/IP for Single Connection – Linking Face ID to
a single computer using TCP/IP requires Ethernet
10/100Base-T Crossover Cable.
The cable can be used to cascade hubs or to connect
Ethernet stations back-to-back without a hub. It works
with both 10Base-T and 100Base-TX.
Joint 1 Pin Joint 2 Pin
TX+ 1
• •
3 RX+
TX- 2
• •
RX-
RX+ 3
• •
1 TX+
RX-
• •
2 TX-
1 8
TOP
FRONT
1 8
1
2 3 4